This allegation must be the OxyLED definitely not put up because the beam is strong and provides a clear view in the vicinity. The handling and installation is correspondingly simple, because a tape from 3M is already attached. Pulling off - anpappen - Done. Is operated with four (!) Batteries, which may respect. The resources not sound perfect, is the priority area of application however no alternative. Solar Storm and are eliminated, a fixed internal battery cell to charge would possibly still possible for the current selling price but probably not very feasible. After all, "eats" the lamp without hesitation batteries, the damage therefore has its limits.
To complete some Handling:
1. The lamp or the built-in sensor will react only when it is dark. In daylight shows the bar no reaction.
2. Before gluing in cabinet and drawer should be considered in the later battery change. I at least have the lamp first glued completely painless completely reversed.
3. The sensor works like a motion detector, thus responding to a manual wiper in the immediate vicinity. The effect is attenuated or altered by glass.
4. The lamp will change after about 20 seconds, automatically into sleep mode, so go out again. But not if you stand directly in front of the bar to observe this process.
Note 5. Fitting dimensions. In drawers, for example, it may be OK! Width 19 cm, depth of approximately 3.3 cm, height (because of the light sensor) around 2.5 cm.
Conclusion: A pretty little light bar, with an unobtrusive appearance, faster and more efficient assembly, accompanied to a clean beam. After ten days of use regarding missing only the empirical value of the energy consumption, but it is to me almost does not matter if the result -. As here - satisfy.