Important advance is the fact if the TV has a diagonal of more than about 95cm, a rotation of 90 ° is not quite possible because the edge of the device abuts the wall (the arm in this regard would be longer, but turn increases the leverage on the screw fastenings) - but is clearly stated in the product description.
Important also read description and not simply begin even to work, because on the one hand the installation manual is very good, on the other hand you then save yourself time and trouble - large parts of the bracket are already pre-assembled and the system itself is a logical and practical (eg when the holder is sometimes mounted on the wall and you have screwed the counterpart on the TV back, the unit can be easily hooked into the bracket first and then without problems not tighten)
The distance from the wall is actually very low and are not at the same time enough space available, that the connection cables are not kinked - all the parts are supplied available, especially large, long screws, long dowel and if necessary even spacers for mounting the SUPPORT- counterpart on the back of the TV
VERY IMPORTANT: When drilling necessarily schaun that drilling clean and not too big a hole, and especially deep enough (the screws are longer than the anchor, so recheck hole depth with screw length) - the anchor must in any case extremely tightly seated in the well and the Tightening the screws should work the first time, because if you get turns the screws, hook into this very strong in front of the rubber of the anchor and the anchor begins to co-rotate in the well - because I had first worked unclean, I had 3 of Replace 4 anchors and all then did not have a very tight fit more in the borehole - acts due to the weight of my device then during the extension of the arm as much leverage on the upper holes that the plug be pulled out - I must now therefore yet or we clean with new dowels and glue or possibly larger screws do - a lot of work for nothing because I was sloppy
Also very important: the plate, which is bolted directly to the wall, is not centered on the TV when the holder is retracted, but slightly to the left or right of center (depending on how to fold the support - both variants are at all times possible) - so in no way measure the edges of the TV set, mark them on the wall and then centrally mark the 4 holes, but first think about exactly where the TV set is to hang in the retracted position and then the distances from the center calculate and measure the left or to the right - that requires some consideration and is not so easy - best cut a stencil of the TV set out of cardboard and the bracket with tape on it stick, so you can imagine the end result on the wall better and try can - so you can for example also test the possible angle of rotation on the wall quite well in advance - that the mounting plate is offset from the center, is in principle not a disadvantage and may even be an advantage, namely, if the left and right outer edge of the TV -device to be mounted near a wall edge and the unit would complete 90 ° turn around the corner of the wall around (most certainly an exception application, but in the design of our living room exactly the way, after I had been looking for)
Overall, for the reasonable price so excellent, stable and quality product that is suitable for a variety of different hole dimensions TVs.