Accessories:
It is to start in the small but elegant packaging everything either immediately with the included evaporator heads or the RBA base for self-winding. In addition, a complete spare seal kit, replacement glass for the tank, a mini screwdriver and cotton is also included.
Processing:
Both the tank and the RBA base effect clean and precisely manufactured. It hatched and tweaks here take the apart and assemble at any point. After the first time Filling the tank was shot the same time in all directions, shaken and (accidentally) thrown off the table, the results of the small use test: Absolutely tight! No Siffen, no drop and no leakage!
Assembly:
Since I have actually bought the evaporator for self winding, he was immediately disassembled and the standard head against the already pre-wound RBA exchanged basis - So I can to the standard heads not say anything. Winding here is super easy, the screws take the wires for future reference. Holds all and remains as it should be.
The assembly is as simple as cutting, through the good manufacturing it cooked up here anywhere, it is not to make any violence necessary to the thing ready for use again.
Finally, the vapors:
There is no screw for filling (at least I would not have discovered), you simply screwed on the tank and filled it - works without dripping and spilling.
The Airflow Control is achieved by a rotating mechanism tip. There are 3 settings which locks the ring, but it is also possible without problems, to opt for a position in between, the ring still remains where he is.
I myself have wound with 1.5 Ohm. The steam result and the taste of liquids is 1A.
Conclusion: An inexpensive tip evaporator of the purchase in any case is worth.
