Well: After connecting power and video cable I turned on the monitor and the PC. I changed in WINDOWS only the resolution and everything worked as it should be. I use the DVI port on the way.
The buttons for adjusting the various parameters are located on the bottom right, not visible in the frame. They are palpated with the fingers. You have to arm and hand so turn to operate from below the keys. This is awkward if one uses the Möglichenkeiten repeatedly to switch between the office mode and the movie mode etc.. Why these keys were not attached to the top or right / left corner of the frame? One can speculate.
A blue line, also at the bottom right, lights up when the unit is turned on. The Power I had actually looking for, because it is hardly visible: He is also the bottom right frame; you type at him sideways. There about I would have liked the adjustment knobs.
It is good that no pixel errors can be seen. The viewing angle is a bit disappointing for me. The ananloge EIZO monitor, I had so far was because better many times. Since I use the monitor at the desk and I therefore little move, the color shifts are quite strong but when you get up from the side and standing shelf a look at the picture toss möchte.- I move right-left of the desk, so there it participating at perhaps 1 m amounting lateral movements no problems.
So overall a "price-value" device. It worked from the very beginning, no dead pixels. Therefore recommended.