A small installation report!

I do it a little auführlicher:
There is a good case. The quality of the individual parts is above average, but just the way it must be.
Rear plates must not show off how often break out in other cases, but they are all screwed individually and can be used so later. You are reticulate, so can also be air out and are lacquered in a blue and fit so chic in the big picture when peeping through the Plexiglas.
In addition, some cable ties and necessary for the motherboard mounting screws were included. All in matching black. The side walls can be removed very well and fit. In other cases has already made mad me. But are extra screws in and unscrew on manually doing. So you do not always swing the screwdriver when you quickly want to put a harddisk into the case. For this simple plastic drawers are provided. It would like to be allowed to be more than two, but there are also mounting frame for permanent mounting it.
It is worth knowing that can be easily expanded supernumerary hard drive bays with a bit of care to get more space (in my case, for cable routing).
In the sheet for the board assembly (in a nice blue) some holes are punched through which you can lead the cable to the back to make them disappear completely from view. But be careful! It will quickly narrow. In my case these holes collided with the SATA ports of my "Gigabyte GA-970A-UD3 motherboards", the fact is not perpendicular to go by the board, but to the side. But this is perhaps to be regarded more as a weakness of the boards.
Attention also with the combination of PSU and board! By lying down power supply for I have now a diagonal end ATX power cable because the second sitting at the top left on the motherboard, but the power supply is now down. The cable is unfortunately hidden too short to guide it on the page long. Control architecture from the mainboard and the case previously. Possibly also simply use an extension if a disturbs the visible cables!

When at some point the exciting moment came to see the blue-lit fan in action, I was thrilled. It looks off rather clumsy, but in operation it is very classy to look at.
For the installation of CD drives and Co this practical Clipper are that a spare that annoying Schrauberei and later allow quick change.
The three blue-lit, transparent fans have been pretty quiet. They look very chic and well air compartments of the components. So I think that even overclockers are likely to have their enjoyment of the housing. The fans can be speed-controlled and well-betriebeb when you been attached on the board, but considering that you meet it must have three FAN connectors. Otherwise, they can be easily operated with the power supply unit and operate as constant, what they can. One or the other film is likely to be then drowned uncomfortable if the baby is quiet. But thanks to the slight dismantling of the side walls, to the fan can at pending films evenings deduct simply necessary =)
Under my desk while gambling nothing is likely to be disturbing to hear.

A few negative points there are.
The front panels have been really bad to dismantle because they were bolted on the inside and those screws were very inaccessible, but after wenigten minutes this was done. In addition, only a shaft with DVD & Co are stocked. The second leaves room only for a floppy, if you do not want to undergo more Schrauborgien to remove an internal guide plate, which is also very difficult to access.
Same area, different problem. The overhead USB and audio ports are sure nice but not very practical. Attached USB cable dangling in front of DVD slide and Innenbereicht raises a similar issue. When you secure the drive I almost demolished USB wire strands that dangled in Sacht! One only had to make some beauty work before they could act freely, because the USB and audio controller cable hung directly in DVD slot. That was already the unschönste the chassis.
The power supply installation was also a little friggelig, although I could not find the reason: It was more like me because I was used previously located above power supplies. There is a rather shabby lint, which remains invisible to happiness anyway at the bottom of the case. Whether this serves its purpose, only shows the long-term test. However, it is easy to remove and therefore safe easy to clean! (The power supply unit draws air from under the housing and blows it right back out, so on carpets care! It must be a bottom air to the housing when the electronics is not to suffer. Probably twice a year ausspühlen the lint filter thoroughly and extensively before re-assembly . dry)
Stupid is also the power or HDD LEDs, because they both have the same color and the Fesplattenzugriffe are difficult to read because the HDD LED lights up and basically just a little flicker. This, however, is likely most users do not become a problem.

All users of USB-3 is said that the front jack no USB 3 controller connector has (not mounted on the board), but must be virtually out as a normal cable from the back, so put on a stern-USB 3 connector to become. Because I would then grab befitting a USB hub, which you provide to the desktop, rather than having the equipment hanging loose in front of the DVD drive.
Further problems could not occurring because no OS is still running on the system.

Caution on plexiglass! For me, an ordinary scratch was in it, but from the outside it is barely visible, and can be combined with plastic polish certainly remove. I noticed it only after everything was already installed, and my caring handling could not be responsible for him.

Conclusion: A top cabinet for this price. Certainly not for the absolute high-end gamers, but my 3,7ghz quad and a GTX 560 perform a fiddle in it. It is processed properly during installation and prepares little worried. It's not too heavy and especially to look very nice. A good choice and I can not advise against it.
The geschummelte front USB 3 port annoyed me a bit, but at the price can that be really do not care.
I would actually give 4 stars for the assembly, but the look and the price let me come to the 5 stars.

I hope I can help you with this information.