In other recessions I had read from a fault whereby the feet differed along with the tracks from the actual installation dimension.
I have a Nobilia kitchen with cabinets in standard size and the frame fits perfectly in the closet, only together with the MW I suddenly had no chance.
Under and above the empty tray (for MW) conventional manner are of course other units with their respective doors. The bottom of a standard cabinet is 10 mm thick. Each door above and below, of course, claimed a few millimeters for the attack.
The installation microwave is on the enclosed rails as high in the closet that the door on the MW no longer closes.
Excluding feet away, slipping the MW out of the closet.
Cuts to his feet a little, they no longer fit into the recesses in the rail and slide back out.
Leaving aside the rails completely gone, nothing works.
It was not possible for me to cut or file the four round hard plastic parts in exactly the same length.
I had three DIY scour to find feet which had the right amount (approx).
The rest I compensated with shims until the device was sufficiently stable mounted in the cabinet.
Another shortcoming was the instructions. In the installation instructions subject "NOT Predrilling". What then? All screws were so dull that I would have the rails without pre-drilling never fixed.
Now I had the unit on the third day finally in the closet, only to find that the lock screw which is to be passed through an opening in the front, does not apply to the closet floor.
Problem, this (only) holder must first be cut to fit.
Everything out again, now still pre-drill a hole at the latest, and hope that was not too much cut off. Even here you have to appreciate what is too much behind the frame.
As I said, the MW unit itself is just great. Only for installation I have a lot of nervous hand.
But it need not be in any way yes.
But since I seem to be an isolated case, here's a tip to the manufacturer.
Beipacken 10 mm shorter feet and each foot 2 washers enclose each 5 mm of plastic. This allows the defect associated with strength of floors / height of the doors balance. It has certainly worked for me, but unfortunately only after two days and three hardware stores.
PS. And that then noted in the product description
(And other wood screws, absolutely !!!!!)
1 point for Amazon, which would have converted willingly, the ambition would leave me to solve this problem.
1 point for delivery and packaging.
2 points for MW.
0 points for installation .... material .... manual.
minus 2 points for work and kilometers that I had to make bite the thing there was.