Of course this article fulfills its role, but I am very disappointed by the quality of manufacture. The plate (which is introduced into the shoe) is thin in thickness (1.5mm), which is below the standard. Also this one is too big and does not fit into the shoe. It will (what I had to) give lime shot on the sides. This will also remove burrs (the room is gross stamping) that may damage the shoe of your camera. Another flaw is the very important game that exists between the threaded rod and nuts (they seem to have been drilled too large before the thread). If you add the price (which in my opinion should not exceed 4/5 euros, because it is after all only a bolt and nut 2) the price / quality ratio is far from competitive. By cons I have not found an alternative, if not more expensive. So we pay more use than the actual price ....