However, there are a few small criticisms / ideas:
- Margins per page in addition 1.3cm, but naturally stable, but that Gummiinnneleben is wider than thought
- The back, except for the frame is completely made of rubber, so any tip Where stands, can damage the back
- Camera is not protected, so that the lens can be scratched
- Around the neckline of the camera is on the Innnenseite (which applied to the unit), an increase which pushes the rubber inner workings of the device,
another option would think better, but for splashproof definitely enough
- Anschlüssel are all the original accessories available, but fit headphones, which are wider than 3-4mm not
- Knobs work without problems
- Fingerprint sensor can only be used when the cover is removed from these, Home button works but
- Speakers are almost not affected
- Touchscreen works great at wiping function, but typing is quite difficult (this works best with a combination of fingernail and fingertip)
- The Quick Start function (camera, light, alarm clock, Bluetooth, ...) are difficult to achieve, because the shell is slightly above the display
- The enclosed screwdriver should be integrated in the housing in my opinion
- The top part of the shell is located directly on the cell phone on, which can become scratched course, but since the screen protector (plastic disc) stands out something, it is as good as on only on the screen
- Should the screws be provided by the Konstrukiton ago with a screw lock out (eg cover from above, locknut or terminals for the screws, ...)
- The eyelet I would not put much hope, looks pretty stable, but since only the top and bottom of the envelope must bear the weight phone, I will not leave me on it because