LE 5W GU10 LED lamp, LED spotlight, LED headlamp, corresponds to a 50W halogen lamp, 350lm, warm white, recessed lighting, energieparende lighting (tool) 5
LE 5W GU10 LED lamp, LED spotlight, LED headlamp, corresponds to a 50W halogen lamp, 350lm, warm white, recessed lighting, energieparende lighting (tool)
especially when compared with those unspeakable GU10 Halo Spots from cheap production. This 5W LED Spot is even much brighter than a halogen spotlight has been substituted for the brand 'Müller light ". Actually, it would have to be less dramatic, the yield of a halogen spotlights could be significantly higher if it were brand goods (to take this opportunity bashing again in this miserably poor cheap manufacturing halogen lamps, which can be achieved by lowering the filament temperature that they work at all, because one has the Glühfadentechnoligie not under control, and so the world billions donated by uselessly wasted kilowatt-hours, the similar the supposed price advantage when purchasing the Bauhaus eat after a few hundred hours of electricity wastage operation again or change completely, but you see I digress, this is about the Lighting EVER 5W GU10 LED Spot 230V. After visual impression and also measured with lux meters, this bulb can replace loose either 50W low production Haolspot or 35 W brand goods spot. The light color is neutral in color, so it has no noticeable color cast, not the countryside. A fresh warm white, the disclosure of 3000K comes so roughly back. The spot size is comparable to the Halo Spots around. The savings is per thousand hours of operation on the current price of electricity about 7, ie the lamps price pays for itself after about 1200 hours of operation. Turns As with all bulbs only again the question of whether the LEDs and the voltage converter electronics persevere even long. That's always been somewhat problematic, because of the spot size and the waste heat from though only modest 3-4 watts, but enforce the semiconductors may unduly. Here the chaff is then separated from the wheat. Whether this led spot belongs to the wheat, will be shown during use. I post to if necessary. At the moment I am more than satisfied.
Two small tips: if the onset is difficult, possibly something graphite spray or contact spray spray on the terminal studs, possibly on the ring socket. This facilitates insertion. Also, make this LED spot use only where air can continue to flow through. The spot has ventilation holes, which only work when the air behind it can also flow out. This will usually be the case, but closed cup holders, for example. Would prevent the.