The protective glass is supplied with a microfibre cloth and an alcohol (?) Cloth, which, prior to the application used to clean the display. The glass itself is protected by a film per page that will protect them from dust or fingerprints. The films are labeled with instructions, from which one can recognize at what stage of mounting the respective film to be deducted. A simple guide for mounting is also included. I have the display of my Notes first cleaned with the alcohol swab and then with the microfiber cloth. The shower or similar dressed, so that the air is cleaned of dust, I did not, because it's not necessarily dusty with me or because I can imagine that the silicone coating would stick to suffer from water vapor. Sure, but I'm not there. The installation went absolutely perfect. I have the glass at first adjusted and then hung up. Once the glass touches the screen already sucked it firmly almost by itself. About halfway through I then noticed that the glass is no longer perfectly straight rests and I lifted it yet 2, 3 times what the adhesive coating has absolutely not mind. So quite as risky as some might think, this money is not invested. When I found the perfect fit, I again pressed lightly on the glass to secure it permanently. There were a few places that looked like fingerprints. If you find something like this with him - these are no fingerprints that are located on the adhesive side of the glass, but small bubbles aneinandergereite! Mir is the only become clear after about 20 minutes futile Drüber wiping with different cloths! If that's in someone similar: A somewhat stronger pressure is sufficient here and the bubbles dissolve formally into thin air! The glass is perfectly bubble free and it is impossible to move this even in retrospect, when it's first fully bonded. If it does not fit, help probably scrape with a knife or similar nurnoch The fit is excellent. The recesses go perfectly past the camera and the sensors and of course there is a cutout for the Home button.
Who worries due to the thickness of the glass makes itself: The glass is just as thick as the Home button is to the glass on the same level 1: 1! If you wipe over the Home button with the finger from the glass from one notices no difference in height but only about half a millimeter, which is a 'gap' between home button and glass! Personally, I think that even for positive because by the Home button with the stylus can not slip off because the glass then offers a slight resistance, or merges the Home Button formally with the glass surface, which I personally by feeling her like better than no glass!
From me there for the glass an absolute purchase recommendation Rec! The installation went very smoothly and should go well from a lending by following the instructions without a hitch! From transparency ago to recognize no difference to the normal display or be color and luminance of the display is not affected. Also there is no difference in the sensors and the detection pen with me.
The only criticism I would have to complain about would be that the glass does not come from Germany and thus the delivery period can last a little longer. However, I have ordered in the Christmas period, which also could have a negative impact. Since this point but does not affect the product quality ansich, I let him not be included in my rating. And even if I would do that, he would urge the Article nich of the 5 * rating. This gives here a high-quality glass for the price of a more expensive premium film that preserves an even against drop damage. I think this is money well spent in any case, considering that a display exchange Samsung will cost more than 100. Because rather provisions!