I have long considered how I our now over 3m high Conifer hedge get back to size. Properly Ran will not get you, a normal chain is too high and the crop damage would also be disproportionately large. After some research I have I then opted for this device. Due to some Renz ions, describing the high oil consumption, I have still the same one 5L canister chain oil dazubestellt (inexpensive of course). After an on-time delivery, the whole was assembled. There following should be noted. The telescopic pole is a little drop-shaped, ie you have to push together the rod according to the profile. So it goes then relatively easily and without violence. Best to start up pushing together to the fixing screws and see if it comes easily. The screws prevent pulling apart on the bar length. As a result, the whole thing can not be, however, also disassemble more. As would certainly still room for improvement (- 1 point). Through the rolled cable inside the telescopic range somewhat low, but in any case more than 15 cm (I guess about 60 cm). Now even the chain oil (there is a small bottle -a filling in) and off fine. The absolute hammer, after an hour were 30m Hecke to size including Mark the tw. to 8 cm thick trunks. The thin twigs with the Hedge trimmer .... ready). For oil consumption I can not say anything, in my opinion, to moderate, the oil reservoir is not very large.
I wonder why I have not already bought the formerly part. This investment was worth it, especially since several trees still waiting on me.