Completion of the order, including name engraving very good. The doorbell plate makes a high quality impression. You could, however, be slightly larger (eg 15x10 or 18x12 cm). The visual impression after installation is a bit limited for my taste. The assembly, however, is due to structural deficiencies are not without problems. The fixing of the plate by means of two threaded pins einzudrehender on the back, to be then pressed into the previously embedded in the wall 8 mm plastic anchors. These holes are with me in a brick wall that provides the anchor is little scope for Ausspreizung. The screws were found to be significantly too thick. A pressing of hand was absolutely impossible. A turning of the plate with a hammer (chump inferior!) Was only after drilling out the plugs (3 mm) possible. Without boring the pins would have been not at all pure. To make matters worse fell due to the vibrations from the top of the bell button, which I then attached with superglue again. Extra costs but about 10 euros. Because of the inconclusive construction of Fasteners two star deduction.