My system: Ci-320 nano (Barebone), upgraded with: 128GB SanDisk SDSSDP (cheapest, less than 60 EUR); 128 GB SDHC card (existed), and also present (2012) 8 GB No Name "Komputerbay" DDR3-1333 MHz !! 1.5 !! V. Memory tasted just - running! After specification but 1.35V required. Installation without complications and very positive! - For the SSD is a complete mounting frame with all SATA connectors as plug slot available)! Bluetooth (Microsoft Mouse and Keyboard) and Wireless Dual Band - without problems. Operating System: Win7 / x86 SP1 Ultimate (32-bit !! - to install later) RamDisk 4.5 GB (for all temp files, cookies, internet Tempfiles, pagefile, etc.) Disabled IR sensor in BIOS Achievable resolution (unlike the manual) at 4K monitor: HDMI: 2048 x 1152 60 Hz (normal operation of the CI320 proceeds only at Full HD Monitor with 1080P) DP: 2560 x 1440 60Hz I'll give you also the performance index from the Control Panel (only for orientation): 4.2 Of which: Processor: 5.7 RAM: 5.5 (running in dual-mode 128-bit) Graphics: 4.2 Game: 5.7 FP: 7.3 For appearance and handling: Housing affects wertig, matte despite plastic - no fingerprints !, relatively hard by the passive cooling plate at the upper lid. Connections excellent and sufficient for all modern appliances, incl. ESATA, handling. Calculations: Operate the computer in parallel, as a "second-home-office" computer, with multimedia use. Ranging from full, even when compared to a desktop with i3-2120T (except 3D games are the graphics not her). Multitask - no problem. Have currently running in parallel: Office, Internet open (multiple windows), multiple PDF, parallel running encrypt a partition and 20 GB of data to be copied. - No locking or falter! Processor not at full capacity! Multimedia performance: for full HD - no restrictions! 4k I tested a demo that with file parameters 24 frames / s and a data rate of 35 Mbit / s on HDMI 2048 x 1152 - justifiable liquid ran, both with available hardware acceleration "Quick Sync", and only software rendering , At the DP I have not tested. Conclusion: Recommended as home computers, with normal "multimedia use without restriction!
Now for those who want to install possibly Win7x86 (is not provided from ZOTAC and are no drivers!). Intel helps "(speaking of possible hardware limitations of the PC manufacturers, therefore" Generic Driver ") To boot in BIOS must: be "legacy" activated! (I believe: "legacy / UEFI"). The default is only "UEFI" I had first installed for testing, from a USB stick Win8.1x86. Went without problems. But since I for some programs need Win7x86, try this. USB stick did not work, USB DVD began and then getting canceled. Then have the 64 bit DVD version taken the start. In order for the partitions deleted, the 100 MB covered UEFI (are plenty of warning messages). Boats started with 64 bits (asks for creation of a special Systempartition- affirmed and even canceled)! Then switched to 32bit DVD and everything takes its course. (On a new disk, the 32 bit version may perhaps start with no problems.) Windows we installed only with VGA resolution. For all other devices go the 32bit ZOTAC driver or the latest Win7 Intel driver. As HD display / audio driver you have to download the following Intel version: Use Intel HD Graphics Driver for Windows * 7/8 / 8.1 32-bit verse 15.33.30.3958 from 10.23.2014, necessarily the ZIP version:.! Win32_153330.zip. On the Intel web site is also the release are Notes (pdf), in which the Celeron N2930 processor explicitly mentioned and the Installation Method on Device Manager, update / Local Disk right mouse button / driver / have a disk / disc is described. About "setup" of the decompressed file does not work. So you can also install the drivers for Bluetooth and WiFi if you do not want to have all the graphical ballast of operating programs. Have Fun!