Completely inaccurate Wasserwage and not to use end anchors!

Due to the consistently positive reviews on here I've decided this wall mount for a 49 inch LED TV to buy. Since I had previously used a Hama wall bracket for a 40 inch LED, which had to be mounted easily, I was expecting me with this wall mount a similar effort.

Shipping and packaging were as usual 1a, just as you would expect from Amazon is just.

Assembly:

The wall mount, the two tracks at which are attached to the TV, all kinds of screws and spacers to the wall and the TV, and an instruction manual.

The latter can not be regarded as instructions for use, because it is hard to read, for me at least, the text was partially blurred. Nevertheless, I have attached the wall mount according to assembly instructions and was surprised directly, because after the built-in spirit level hung the wall bracket in scale, with TV but was more than clear to see that the wall bracket was mounted wrong. Since this seemed to me funny, I put its own spirit level on the wall bracket and lo and behold, the built-in spirit level was completely inaccurate and softened considerably by my Wasserwage from. Thus, now three holes were drilled too much into the wall and it had to be re-drilled three holes.

Let us step up another problem, the anchors, which are accompanied by the entrance with a plastic ring, the anchor should no grip and spin in an older wall, can be the anchor does not pull out easily, because it is greater than the rails of the wall mount and does not fit through the pull. The wall mount can therefore only be removed by force.
After I had now replaced the plugs, with my spirit level the correct holes have drilled at least the wall mount was in balance.

Problem number three follows immediately, the TV is up, as usual hooked into the wall holder, but below are two screws are tightened once the TV hangs on the wall. You have to remember that the larger the TV, the greater the distance is just one has to get it over with, to get to the small screws. Secondly, each TV has different depths, so this makes the additional assurance that you will have with the tightening of the screws, even more difficult. For me it was impossible to tighten the screws halfway, as I unfortunately do not have a screwdriver having a length of 50cm. Who thinks now that one could simply put the screws before mounting the TV, which you will notice that you can no longer mount the TV.

On my old wall mount the TV was secured by iron rail that was in the end simply pushed down, no unnecessary screws more and you could easily solve the backup again, such a system I expected especially with a wall mount for large TVs. Too Bad ...

Mitlerweile the TV on the wall without securing the screws, but it was annoying, stressful and all in all I would not recommend this wall mount. Then rather drauflegen a few euros and buy something sensible.

I hope I could describe to you my impression of the wall bracket, with questions of course I will try to answer as possible.

The two stars are there only because of whatever class delivery Amazon and due to the price.