Cover .... well, fixing definitely refuse

I once exceptionally retrieved from hardware store to cover, but since it is the same, I want to get rid of times here my two cents.
We looked at the cover in Hagebaumarkt, while the Route66 and an Indian motif came shortlisted. Since our boys in front of Indians are afraid, it was this.
Unpacked home I noticed the same time that the (presumably laminated) decoration at the edges of the lid has sharp points, so here must be carefully reworked with 400 sandpaper, which costs the first star, especially when children's hands are near, is not so great.
Two other stars will cost the attachment. In an Aldi-cover for 19 EUR, I expect nothing else, somewhere to catch so on with the savings, here at a 3 times as expensive part is the not at all. First of all positive that we can turn the Editions by loosening the screw in all directions, should in conjunction with the 3 threaded holes can find the right position for each bowl. The supplied threaded rod is rotated in the associated bore, so that the lid rests completely correct and the centering causes the threaded rod into the hole of the bowl, which comes after some fumbling still quite passable. Then comes from below a wheel, which together with the centering of the top a kind of leadership of the threaded rod, unfortunately everything from cheap plastic (the threaded rod itself is made of metal, but certainly not quality), then stekt you a large plastic nut onto the threaded rod the thread is then pulled in the disk at the top of a cone, which then presses the thread of the threaded rod, so that it can be screwed. Behind the bowl all very fiddly and really determined to get the so never, What's more, any accompanying written documents under the conditions (will probably prevent that water can topsy run), do not fit properly, you get the not installed without It is since then irgenfwo pinched. All attempts to mount reasonably Establish a cover, fail because of the plastic nuts. Luckily I had the old cover the nuts and washers nor which are made of metal and the best replacement for the plastic nut. So assembled, the lid holds now. For the price 2 star deduction is justified. Who buys the lid, so it should (with the diameter larger than normal) mitkaufen equal to 2 matching washers and 2 nuts, saves a lot of frustration and the fumbling. May put the rubber pads before assembly in hot water, which makes them more supple and they can then be reasonably under the Schraubauflage place and mitbefestigen ..

The seat comfort and other criteria in the daily handling of it, I let myself now not, that's not better or worse than other lids, here nothing goes into the vote.

UPDATE: The cover is returned to the dealer, the screw in the cover material dissolve, thus the glasses and the cover are likely to at least 4 weeks in addition to the bowl. Now I have bought a cheaper model that is better (not great, but it is likely to last longer). Thus, the part has now only one star left, let your hands off of it, I just say!