Bikerset 4

The whole set gives me a solid Eindruck.Die holder (Made in Germany !!) Although
bit fiddly to assemble, as the nuts are not firmly connected to screw,
but after the fixing bolt from falling out. Is just stupid when the half-shells on the handlebars
is mounted and the nut must be pushed so far that the screw engages!
Then was too stupid to me, they've :-) simply glued themselves)
The side of the handlebar, in the bend, the part can not be mounted because the Navi is then wrong!
Register here for missing a further axis of rotation! Centered on the handlebar support also did not work, at least not at
the BMW 1150GS, since otherwise the key no longer gets into it! Something laterally offset happy you but :-)
For journeys with the tankbag optimal since the Navis is very high. For trips without tankr. rather then a
Choose shorter mount. Looks goofy! A little thinner bottom mount system would not be bad, because I
could not fit under the handlebar mounted. Unscrew So handlebar, shell including translated and handlebars tighten again - done. Can indeed work with other mopeds, but just not in the 1150GS.
The bag also does not look bad, and the touch screen is perfect to bedienen.Was is a pity that I
the bag can not rotate upright, is also just on the bracket (Garmin 2360LT is also edgewise) Whether it is waterproof, I can not say for lack of rain, but the cable entry I'm going seal, for safety. Unfortunately, I can not connect my Garmin with the charger in his pocket, because the connection is down, then the bag is too small! Since I have to tinker what :-)
Otherwise, a low-cost solution for non-motorcycle GPS!
Get me a brief holder for the "normal operation" order and good iss :-)
Hope to have helped you!
Servus - Willy
Extension: Have the set last week extensively in !! Tested rain .... and ....
Everything tight! The Navi can properly operate in the bag and the high Holder is ideal for use during the journey, as close to the Fahrer.Fazit - recommended!