The support plate is an element that readily assemble by screwing edge to edge in what ultimately will replenish, brick by brick, cockpit control of your favorite aircraft model. The panel "Pro Flight" then just insert it without difficulty, it is fixed by 4 assembly screws Saitek (included) or other finish is perfect, immaculate rendering. According to the aircraft model, panel, and the reproduction you expect you will have previously placed the masks of LEDs (21 + 28 in the panel in variants provided) slipped sandwich in the light module, both sides sticking magnetically and are fixed to the plate by screws. The finite set of good looks, a real success. FS tried with FlightGear, if recognition and the establishment of the pilot poses no pb for the screen, the combination of all parameters is an expert job that requires long hours of learning, so that FS of the contribution and the peripheral settings. Everything is planned and well designed but I admit that it is a job reserved for the pilot and aviation enthusiasts. However it responds to commands but I do not control enough piloting and I have too little experience to draw all the benefit. To reserve pilots who are passionate, already have experience of advanced flight simulators, and revive or improve through this technique and leisure by making kit so lifelike cockpit.