I have the envelope directly ordered to TF300T it. I am not a fan of leather look, but for lack of alternatives I am still struggled through. I wanted a shell with no frills, the "Slim Factor" I was überigens also very important. The 29.95 I do not just felt now as a bargain, but I wanted the cover to try anyway. To build quality in terms of stitching the inside is first of all slight disappointment set in. It all looks not so clean cut and sewn, it can also be seen on one of the customer's product images. Keeping, however, seems to show the time it gets. The exterior, however, is tiptop. The first onset of the tablets in the retaining clips designed to be a little difficult, they are virtually impossible to bend. I was not really sure if I should dare. So stable the plastic frame of the tablet is not. I then get the tablet from below pushed, the only possible and reasonably safe way. The tight fit of the brackets is only at first glance a problem, because in retrospect I must say, is shaking and sliding nothing, absolutely determined. The two lower brackets are not as tight, since the tablet must be so removed for setting up of these. If you want to permanently remove the sleeve and it stuck again, this product is not for you. Even tighter fitting the clamp that holds to the cover flap. At first we went not to. After very careful bending and drawing I got this but then pressed to the tablet context, it was really damn hard. Just opening. The next two times were not much better, I was about to send the part back. Now the clip is a bit ausgenudelt or it has pulled something, it's much easier but the seat is still good and tight. Also, I have no more every time you open and close the feeling equal rauszubrechen a piece frame. Conclusion: At first I had several occasions to return due to the thought fit, now I find the seat actually perfect. A star deduction there for unsightly seams on the edges of the inside that you could have done better for 29.95.
