The pilot itself is quite aesthetic if not in the middle Detection button swears a bit. The big plus of this lamp is its extreme ease of use. An adhesive tape from one side and magnetized comes with. We bet the adhesive glue under the lamp and it only has to install the light where you want thanks to the powerful magnet that holds up very well. It's really very convenient, especially when changing the batteries. The latter are inserted through a small sliding door on the side by keeping less down so that most affects the small sliding latch. Personally I inserted 4 new batteries of 900 mAh. Note that I tried first to put old batteries (charged yet) but the brightness was quite low. In attempting with 4 new, the difference is really striking. I put my hood on this night because the lighting of the latter is defective (location of the broken push button) and difficult to repair (not achieved something safe and reliable). So if the lighting is necessarily a tone below, however, it is sufficient thanks to 10 LEDs that provide a compelling white lighting. I set it so that it goes off when I approach my plates. If I leave, it cuts in less than 15 seconds, otherwise it remains permanently lit until I digress. For my usage, it's just perfect!
This automatic detection pilot work done perfectly and is triggered in low light. It is very easy to use if you have a metal support through the magnet to stick supplied. Used in my kitchen, it fits perfectly with the use I expected.
Pros: - Good brightness thanks to its white light with 10 LEDs - Easy to use - Excellent value for money with its 50,000 hour lifetime
Cons: - Requires a metal support (not possible to paste or we will not be able to change the batteries)