Upon receipt of the package (which weighs at least 10 kg) were:
- All of screws panel
- The support already mounted ready
- Two vertical rails adapters that will be installed at the rear of the TV
- One of the simplest manual
After unpacking I was pleasantly surprised on the general appearance of support.
It is properly finished, nothing shakes or fidgeting.
The metal in the solid air and welds are clean.
The hardware is complete (they even thought about the TV whose back is domed), the two vertical rails have enough holes for hanging without difficulties.
For my part of the back support (one that hangs on the wall) was quite flat, but once the screws / nuts infatuated well into wall is flat.
Please note this is not the kind of media that installs on the plasterboard ...
Concrete is a minium, although Ricoo thought for installation on wooden beams (see installation plan).
The spirit level is handy (and magnetic) but is too light for correct adjustment of the support. I highly recommend the use of a standard of at least 50cm long which will allow you to properly adjust after installation.
It lacks a scale representing the support sheet to facilitate and ask drilling holes in the wall.
It is designed for TVs between 30 and 65 ", which is mine 46" had no difficulty in finding its place on the wall.
We can move it laterally and adjust the tilt (beware of manipulations must be gently but forcefully because everything is screwed ...)
In short no regrets especially for this price.
TO @
Pogyz