Due to a water damage in our apartment the ceilings were in three rooms away and now after almost two months living in the grotto reattached. There the idea was born, the same everywhere to install LED spots. So I looked for the items together, LEDs, frames, sockets and cable, but had no idea how I get the thing together. I'm not an electrician who deals with something every day. So googled, searched and found at Amazon, this Wago terminals. Just try, I thought. Yesterday it was time that plans for the ceiling was finished. Cables were cut, stripped and the first plugged into the terminal. Simply slip! Loose again, this is also possible with a bit of rotation, the cable has one out again. Best of all, you have two Ansteckmöglichkeiten for fixed cable. This means that you can put a second cable in each terminal, which is drawn from there to the next LED. My first plan was namely so that is drawn from the main port in the center of the ceiling to each LED a separate cable. You have to now no, but draws two poles of one spot to the next and has all spots in parallel. A central distribution eliminates it and it saves time, and distribution cables. The versions of the spots have stranded cable and are infected on the other side of the terminal. Simply clamp squeezing introduce wire, release firmly. Remove the wire when it is but with a difference, without any problems.
In two hours I had bathroom, wired hall and children and was thrilled. How long I would have screwed with luster terminals, twisted, etc.? When inserting the LEDs as a function test everything works immediately. There was not a single problem. Just awesome. These terminals are perfect for such wiring, as I have just done. Highly Recommended!