I have been thinking in advance if I should take that risk and I asked if I can assemble a slatted frame and whether the quality of the final product is really good.
Finally, the assembly was not all that difficult, and the end result convincingly.
Ahead one should look at the assembly instructions correctly and to lay out the materials. The slats are available in three different sizes, the shortest of hardness adjustment used. The medium used to long for the rest of the movable headboard and. Tool is up on a Phillips screwdriver none needed as an Allen wrench is included.
Below are some small tips that make the construction easier:
1. The frame is mounted as the first. Here it is helpful to one long side only half screwed in the screws to have a little more air in the assembly of wooden slats.
2. The movable headboard Preassemble, but leave the metal hinges still away.
3. The plastic bearings can be introduced with a slight pressure in the precisely fitting holes of the frame.
4. Prepare battens
5. In each case lay a short bar with a long bar and connect the right and left with the slider.
6. The slats are now starting first inserted from the head to one side in the recording.
It is recommended that each slat first be inserted into the guide strip to prevent the subsequent threading.
7. Now the slats are pressed on the opposite side in the lead and the bolts tightened.
8. The driving band of the slats is now aligned centrally, easily attracted and fixed by means of screws on the bottom of the frame.
9. Finally, you can now engage the metal hinges of the head portion.
I hope my little guide will help in the assembly, as the manufacturer's instructions are quite meager.