Hello Everybody, At first I was skeptical that you rausbekommt from 4 simple Spray Cans 4 evenly coated rims in Matt Black. Surprisingly, yes! Email How to: First I removed the wheel, because you better come with the box between each spoke. After the hub caps Remove taken out and made the rim with a neat rim cleaner clean. One should definitely clean the rim thoroughly, otherwise there may be unsightly bubbles are created when the Sprühfolie. Finally, the cleaning Rinse off / hose down and dry is best with a chamois or a cloth that does not fluff, the rim with clean water. The cards, which are included in the set, rich well of a 18-inch rim. Before going to the spraying still taping the Vetnil and then you can start. Most important when spraying I fande the first layer. If this was well applied and covering, you can later assume a uniformly coated rim. I have the box kept at a distance of 15cm-20cm from the rim to avoid selectively spraying and also to avoid the loss of Sprühinhaltes by wind. Once the first layer has been applied, wait about 10 minutes until the sheen has disappeared, after that you can start with the 2nd and thus final layer. IMPORTANT: you should the can never spray completely empty because settle apparent in the can down slightly "Folienfussel" and then as soon as the can is coming to an end, be with rausgesprüht, unfortunately happened to me once, which can be annoying for the trained eye are perceived. You should pay attention even if you sprays between the spokes that are not too deep attaches the can and then collides with the bottom of the can against the rim, are unsightly dents on the freshly applied layer. But is not a problem, the place you have to simply spray evenly thick. Otherwise, I'm satisfied with Plasti Dip. The whole effort has taken some 6-7 hours, the time should be planned in any case. But the result is quite definitely.