Notice translated:
LCD smart charger.
Instructions for charging mode:
A. If you do not connect, the LCD shows nothing.
B. If you do not install the battery and plug the charger, the LCD displays all the data and then shows between the lines, "NULL", load current (0. 5 A) and "CHG" (load).
C. If you put the batteries in the slots, the charger can recognize the Li-ion or Ni-MH / Ni-CD automatically, it shows the voltage and current capacity symbol and battery charge going forward (from left to right). (Press the button momentarily to select the charge current, 0.5A or 1A)
D. At the end of charging, the rings ring tone (the beep charger).
Instruction capacity test mode:
A. Make a long press to access the capacity test mode and the LCD shows "CAP".
B. At the end of charging, the rings ring tone (the beep charger). For laccès the discharge status, press the button momentarily and then the current discharges. When the voltage and the battery symbol is displayed, the down position of the emitted power (right to left) starts counting capacity.
C. When the discharge cutoff voltage is reached (Li-ion batteries, 2.7 V, Ni-MH / Ni-Cd battery-0.9V), then when the discharge is finished, the tone rings ring (beep) .
The number of capacity in position is the actual capacity (indicated at the bottom of the LCD displayed in mAh).
And then begin to access the status of the charge at the end of charging, the ringing tone rings at closing.
In short end of discharge, it indicates the capacity (mAh), below the LCD, the batteries concerned, starts to beep and starts are battery charge and re beep end of charge.
You'd be amazed between capacity (mAh) displayed on the battery and that it has in the "belly" actually. If you use a charger "dumb", the batteries have probably suffered and lost their capacity.
Test to follow, 2 batteries NEW TrustFire 26650 5000mAh ()
Qty.