Indeed, in general, first we identify how we will ask protection (about 0.5 mm on each side); we withdraw, the protective sticky and rests just ready where we had spotted ... which usually is removed is never the exact position: if one is lucky, protection is just ready up and not biting at the edges.
If it bites, we are left with a protection that protrudes slightly and irreducible bubbles at this level (which can never join).
And if you have the wrong idea of wanting everything off again to correct the position, it is almost assured trash (off protection is to see happen from who knows where all the dust / hair outside ... and irreducible bubbles that go with ...)
Here, before actually removing the protective rectangle, it will take off a tiny rectangle provided for (step 1)
Although its protection is placed as it should, it's easier with a protection which has not yet become sticky everywhere. And if you want more correct position, you can take the risk off again this small area, because there is little chance that dust latteigne weight (less to do 15 times I guess?) Or Anyway, it will be on a very limited area.
Once satisfied with the landing zone, proceed to step 2, the most delicate: remove protective sticky underneath (the one that will allow the protection of adhering to the screen, but in general also attracts this time all the dust from the area ..). That's pretty much done because one draws from below (hard to explain) thus exposing only the adherent area very progressivement.Bien on must be gently, pushing out the air bubbles "to the exit" as usual. It did not pose any particular problem.
And as the final my position was correct, and that no dust was home, I could remove residual air without problems and see the result after step 3 (breeze, or the film is removed external)
All text for a poor screen protector?
Firstly because I wanted strongly advise you to avoid a lot of sub brands that are probably too electrostatic material, so full of dust before beginning installation (...). But that, it begins to know: better to buy one a little more expensive than 2-3 for the same price, which will inevitably end up 1-2 in the trash (with guaranteed excitement). Hori is rated among the protections on ds (see comments), though a bit pricey.
Secondly because I just ask a Hori Protection 3DSxl yesterday, and despite the brand and good quality, it was not a great success.
Well OK, late night stuff, but when I found myself reading the doc because I was not too sure about the pose, with a much less intuitive system, and much less convenient and more risky (risk of malposition , exposing a larger surface dust): good headlock.
In the end, some bubbles and dust that are not seen too (but I see it ^^) therefore not catastrophic, but disappointing after the experience WiiU
In short, very good system installation, better than what I have seen before (I do not know if others have had the same experience)
And if I take the time to write all this is because i hope that the brand will have positive returns and will adopt it.