The Case is working properly. The iPhone 5S is first inserted into this plastic cup, so that the buttons are protected on the side of the iPhone. Then, if necessary, earphones and / or charging cables are routed only through the supplied rubber gaskets and then through the openings in the case and then connected to the iPhone, then everything will be used exactly fit into the ausstaffierte Rubber Case.
Nothing is loose, fluttered around. The iPhone could in this case certainly the fall from a skyscraper survive :-)
The controls left on the phone (loud / quiet switch, MUTE switch) can not be used while the phone is in this case. The standby switch can be operated and the home button with touch-ID can also be used. The touch screen responds within the Cases as well as without Case, exemplary.
In some reviews is written that one can read the iPhone out badly because the sunlight is refracted on the display sheet of the case and hidden. I can not confirm so absolutely. In my case (Rain Case 2.0) is a "frosted" film installed. I find awesome. One thinks in the first moment when you see this film, because you can see through so nothing but it actually works great. It reflected on hardly anything, even less on the iPhone display itself! I have the case mounted centrally on the handlebars of my motorcycle. It has the same angle of inclination as my taps and the display of the iPhone is therefore absolutely clearly legible. I had during my first test drive one afternoon sun obliquely from the rear, as it was a little less contrast, but was still legible, the same effect was also on the fittings (speedometer) of the bike. I can say clearly. When the light conditions allow a reading of the instrument, I can read my iPhone properly in this case.
The iPhone is sitting with this case very low vibration on the handlebars and potholes can not impress the construction. However, I have the included rubber band yet integrated into the holder. I should not have to do as the handlebar is thick enough. But it has the advantage that the holder is thus doubly rubber sprung mounted and which acts almost like a vibration isolation. I would also recommend to make any so.
When the bracket, tighten the handlebar should be careful, is also in the manual - to firmly come from! There's all plastic, one should not draw too tight it. However, it is not even necessary, because with gently tangible mounting the holder was sitting with me very firmly. I could then turn it easy to optimize the angle, but in the end position is he remained the whole time.
For my purpose of this case is 100% exactly what I was looking for. The purpose is to have on longer bike tours safe, water-proof place for the iPhone in the field of view, since it is used as Navi. Well, one could interfere in mind that there is always something fumbling to piddeln the iPhone after a tour out of the case out. But as the touch-screen operation is functioning properly and even the Touch ID sensor comes within the cases, the phone at small tour breaks do not have to yes right back pack from the Case. Simply pull the case from the holder and take it, finished.
One tip for those who obstruct the cable (earphone or charger) with: In order to solve this cable from your phone, you have to open the case and only fumble out the iPhone again completely, which is a bit annoying. I use for audio playback therefore on the moped no earphones but Koppele phone and helmet via Bluetooth = one less cable. For the charging cable I would choose a shorter solution. An appropriate USB socket should also close as possible fitted to the handlebars when Case and Apple 15cm cable be ordered (Attention, only use original cables, replicas may not fit through the slot in the case!). In a pause then you pull the USB plug from the socket and clicks from the Case of the holder. Then you can take the phone during a break with Case, it then depends only 15 cm short USB cable like a little tail bottom out, but apart from some silly appearance does not interfere with the use of mobile phones in the case.
I'll see if the whole also from the material quality of her is such that it participates in an iPhone-life.
One more little thing: To buy myself moving also the way how the dealer handles the reviews on Amazon. Once a customer shows dissatisfaction there is always offered by the same comment repair or exchange, which I find exemplary.