The initial start-up is quick and easy. Unpacking, remove the sticker, just wipe with a cloth over it and you're set to go with the cooking pleasure. The disk offers 9 different temperature settings (450 Watts 2,100) also 6 preset cooking functions:
- Hot milk
- Simmer
- Roast
- Frying
- Boil water
- Manual
Especially these cooking functions have interested me most about this record, so I tried the first hot milk. My little girl and I like to eat even rice pudding. So I have the hotplate prepared, showing a pot, poured a pint of milk, put on the panel and select the appropriate mode.
In this mode, there are three setting levels, depending on the amount of milk to be heated. I just wanted to warm up a pint, I could select Level 1. About the power switch to activate the induction plate. Immediately the fan starts, the still appeared quite loud to me. Thereafter, the program and the level 1 is selected. After 3 seconds, catches a moving light sequence in the display window to run. This goes on until the set temperature is reached. Then the program will automatically stop and the drive will beep three times loudly and clearly.
In the milk, this has worked out perfectly. The milk was hot, but not boiling. The board turned off automatically, only the fan ran for a while, until the plate was cooled again. Then he turned away.
Following this success, my husband wanted to make soup in the evening. So he chose to cook the program water. This mode is designed to function as similar as with the milk. Just with water and a higher temperature. Again he went so ago as I was. The moving light sequence began to run and the water warmed. However, it is not bleeped. Although the water was boiling at some point, the board remained silent. According to the manual, the boiling point would not be recognized in too little water. However, the minimum amount is specified with 0.4 l water and it were used 0.75l. Even with a larger amount of water we could not produce the Signalpiepston.
There had however so well in the milk, we tried it again the following day. Unfortunately, again with the same result. The plate heated the water to 100 ° C and not bleeped.
The other functions we have gradually tried. The plate is heated by our feeling faster than our induction cooker. The display is easy to see and read, the operation is very simple. After a short acclimatization one has to operate as downed that one practically does not need the instruction manual.
The timer is easy to operate. Begins the last minute, the display automatically switches to second display. If time expires, it beeps and the panel switches itself off.
The manual is written in 8 languages. At the very beginning are the most important safety information in a very large font.
Conclusion:
Apart from the problems boil the water, we are quite happy with the induction cooking plate and had it in spite of an existing induction cooker has often in use.
