Delivered Handytasche not match the image. A figure corresponding pocket I use already for a Samsung GT S-5230, this is an excellent fit. When delivered bag, the plastic material is much thicker, inflexible and acts somewhat clunky. The mobile phone is / should be held by a bead in the lower corners and at the top center. The integrated plastic frame proved for the GT S5220r Rex 80 of these "3 breakpoints" as a bit too small. It was not possible to obtain with gentle pressure the cell phone in the actual holder. 2 attempts ended with the fact that the back cover of the phone sparked by the generated counter-pressure of the frame, since the top (in the middle) bead exactly pushes on the area to open the phones (recess) is intended. Would this material be somewhat flexible and can be thereby push away 1-2 mm, it would probably work. Because I wanted to use but with mobile pocket immediately professionally - otherwise would be the case remained gegangen- only to pick up the sharp knife and remove at all 3 breakpoints corresponding material, which can not be the intention of the manufacturer.
The flap from the magnetic lock is designed differently (shorter) and includes up here on the front page, instead of on the back with a - compared to the above-mentioned case - fairly weak magnetic.
For comparison an Amazon listing, which corresponds to the bag supplied, and that too at half the price. Since I'm not sure whether here a link is allowed, just enter "Original Phone Castle Slim Flip Case Handytasche in Black for Samsung S5220r Rex80" into the search.