Cons:
- The carrier film (not the display foil) is static, thus it attracts dust extreme, big fail from the manufacturer!
- Difficult to apply without foreign body inclusions requires a significant overhead (see Tip)
- NO Antistatic packaging, instead, loosely placed in cardboard, and without carton as can be seen in the figure.
(Could in my case but also by the seller [protector professional] have been sold without email box).
Tip:
I have brought up the film on its own in an air Humid bathroom.
Thus, the film can be applied as possible without foreign body inclusions, proceed as follows:
1. is best to take the bathroom because you can transform this most easily in a clean room, also stands there the shower.
2. Clean the area thoroughly, and aspirate the tile and walls, so that as little dust remains in the room. Everything that is made of fabric, or otherwise as new dust caused, remove them from the room. After 2 hours (when the residual dust settles) again aspirate the large areas.
3. Clean the Cintiq thoroughly and possibly also aspirate (best deposit with the brush attachment of the vacuum cleaner, so that nothing scratched Then the Cintiq in bathroom
4. The film also cleaned and left under the bathroom (most with a piece of tape on a free tile surface with the carrier film side towards the wall stick, so that the film can not attract new Static dust.
(Etc mirror fogged up) 5. Take off outside the bathroom and showers go, run shower on until the humidity is extreme. but not too extreme, not that you stand in the fog and the Cintiq is totally wet.
Exhibit 6. Shower and himself let in the meantime by the dry air, do not use a towel! (Longhair should be careful that the hair in the shower to stay dry).
7. When you are dry and no longer dripping, wipe the Cintiq with the supplied cloth again, and blow with the mouth via the display.
8. The film initially muster described (the first 10-15 cm) as shown in the enclosed instructions. Then cast keep the film almost straight up and the foil Drain bit by bit slowly, always slide your finger along the edge of the film and resulting bubbles equal. Always replace the carrier sheet only 10-15 cm continue in order to apply the protective film, and thus preparatory to the end.
9. After a successful mission,
the question "Was this review helpful to you?" answer with [YES]!
Why all the effort?
Very easily.
1. The thorough cleaning is now hardly dust in space.
2. The moist air in the bathroom binds the remaining dust particles in the air and they sink down, the air is then much dust poorer, also can hardly new dust into suspension, as the particles are saturated by water, they are heavier and sticking almost at place and notice.
3. Your skin is through the shower process also dust, grease and Schuppenarm, also it is still slightly damp, so that less skin particles can detach.
With me only foreign bodies have crept, because I had the film not been cleaned before (she was new and I did not know that the carrier film is so static), as already foreign particles had adhered to the film base it was too late. I have spent the first 10 cm (left) foreign body, the rest is clean and without air bubbles.
