1 arm with suction cup and 2 joints.
A joint for horizontal panning (left / right). A latching end joint for vertical tilt (forward / back), whose knurled nut must be loosened so far for adjusting that can be adjusted in the next catch without effort. The third orientation (tilt left / right) is achieved by rotating the entire arm with variable gesaugtem sucker. With the suction cup can be mounted on a flat and smooth surface (windscreen).
2 Mounting plate with adhesive pad
For mounting on a flat but rough surface on which does not hold the suction cup. The suction cup fits tightly into the mounting plate.
3 Actual Holder for devices with widths from 60mm to 85mm
The holder is connected to the holding arm by the webs of the bracket are inserted in the slots of the holder and the holder is forced to clamp down. When used with portrait orientation, there are below two brackets that are laterally movable to allow access to ports. The lateral holder are pressed against the device until the lock holder with a fixed seat. The latching can be achieved by pushing the slider to the left.
4 Oblong adhesive pad
The holder can stick directly to a suitable flat surface without holding arm with this adhesive pad. (Only once available.)
Parts 2 and 4 I have not in use. Parts 1 and 3 hold me in a Ford Focus to the right of the interior mirror on the windscreen bombproof.
The lateral supports are arranged deliberately asymmetric. If these are to the device due to connections or use unfavorable, you can use the holder also rotated by 180 degrees. The bottom bracket can be pulled to and inserted on the opposite side.
The holder can be also used with landscape orientation.