The equipment ordered and whoosh it was the next day already there, respect! Once examined, found this very wobbly hanging the indicator light in the sheet metal. So without further ado screwed and the lamp (lock nut plastic askew on the thread) screwed right now sitting selbige firmly. A little tip: before taking the small in the first operation, Just tighten all visible bolts and nuts easily, these are often not just all very firmly ;-) So, now oil and gasoline filled (mixture first fueling 1:40 warm-up time according to the manual 4 hours no more than 400 watts removal observed) and attempts to boot. Tighten After 6 times has little then finally received his service and took us by surprise spat briefly slightly to himself, until he was transferred in a smooth operation. Then buy the first load removal, I have him. For the use of one or two flash lamps to 200 watts each and a small smoke machine with 150 watts for outdoor shootings Since flash lamps have a certain sensitive electronics, was my biggest fear, that this could perhaps adopt due to the current fluctuations in the power generators. Far from it, turned on flashlights and triggered the small grunted louder at current consumption and the flash lamp made very good and quickly her job, as one would expect from the Hausnetzt. Even the simultaneous operation of the small fog machine does not have demanded the small electricity suppliers and remained bravely generate the electricity. Positive also that shielding for the exhaust bears his name correctly and is not very hot even after long operation. Something negative can I find the noise of small 2 stroke engine, which in the price range is still completely justified. Tip, use here a long extension cord and the unit about 10 - operate 15 meters, you are with the volume ;-) In this sense ... I'm with the device very satisfied so far, only the long-term use will show what little has so drauf. Greeting Nicole