Instructions for Lagute Bois (LG-B05) Aroma Diffuser / nebulizer:
German User Guide
About the power cord connector (DC socket) are two pressure switches.
Topping FOG button => (M button, M = Mist / Fog)
for setting interval mode or continuous mode and
between the network connection and the M button is the
LIGHT button => (L button, L = Light / LIGHT) for setting whether
Color changes, different colors or permanent light.
There are two modes of operation, intermittent operation (approx. 8 hours) and continuous operation (approx. 4 hours). The device switches off automatically.
Open:
Dry, oil-free hands are helpful for opening!
A slight / minimal left-rotation, with some slight, back and forth, you can open the top cover (plastic lid wooden replica) of the device and then carefully remove the white cover of the then comes (water tank lid) wiggle, decrease. Now you look at the inner workings there is a chip for nebulization (=> Mist chip, which can be carefully cleaned with a soft-object) and a metal sensor (silver, small metal pin), so that the device itself off if no more water is present.
Filling:
The mains plug should always be unplugged before filling!
Then the device with the enclosed measuring cup (max. 110ml) are filled with distilled water. (Maximum 1 cap from the measuring cup, filling almost to level of mean square box in the middle of the unit). If required 3 5 drops of scented flavor can be added.
Closing:
Then hold the device only horizontally so that nothing spills. The white lid of the water tank touched down gently. Then the closure-cap (the wood plastic lid are inside 3 wells at the edge visible, this according to the 3 WHITE NIPPLE put at the bottom of the unit) and close with a small right rotation.
CAUTION: KEEP APPLIANCE LEVEL !!!
Now plug power plug.
Switching off the device by pressing on the 1 x M button (fog button / top), so the device is in the interval mode.
(It runs for about 3 minutes and then turn on for about 1 min. Pause / off. (Fresh filled about 8 hours of battery life.)
=> The blue LED lamp (P = LED indicator) on the other side flashes while the pause mode. (To activate the interval of the mode display.)
If you hold one more time on the M button (all top button / for fog) the device switches to continuous operation.
(Fresh filled approximately 4 hours duration)
=> The blue LED lamp (P = LED indicator) on the other hand stays on.
The RED LED lamp lights up when the unit is connected to the mains plug.
Now you can use the LIGHT button => (L button, L = Light / LIGHT) select the desired setting:
Released => light automatically changes color
Press 1 x => Permanently color RED
Press 2 x => Permanently color GREEN
Press 3 x => Permanently Dark blue
Press 4 x => Permanently color YELLOW
Press 5 x => Permanently color light blue
Press 6 x => Permanently color purple
Press 7 x => Permanently color light green ??
Press 8 x => light is switched off.
If is then pressed it starts with the color change again.
However, the lighting effects are not strikingly visible at the point of
the mist rising up.
Cleaning:
According to the manufacturer, after about 5 6 repeated use of the device or all 3 5 days ago.
If the device is not used for longer IMPORTANT: Clean & dry
to avoid contamination / mildew.
For volume is to say who does not like noise, should refer to an evaporator with candlelight. ; ->
Electrical devices do now times from slight noise.
If continuous operation is set, it is a universal easy lavish / partially bubbling noise (noise = similar a ventilator).
Who RED & BLUE LED lamp disturbs, it can indeed überkleben / cover with something.
I like the unit very well, the wooden replica of falls in our living room, not so much on. Who value on the color change effect
sets, should choose a different model, in this is the
not so recognizable.
I hope that it works long.
(This recession was written by my wife.)