Regarding function and energy consumption, I agree with the positive reviews. Annoying was in our unit to rebuild the door from standard clockwise to the left. To do this, the two metal plates which receive the pins which support the door rotation, be remounted on the other side of the refrigerator. For the top plate to remove the cover plate. In itself not a big deal, and after a brief 3/4 hour also done. What took you so long? Due to inaccurate production was in our unit for the lower plate grad times of the planned three holes to screw the plate left on the floor, accessible. The others were completely or partially covered by the metal frame of the refrigerator. It may be an isolated case, at least the plate now hangs on a screw that was screwed only with great effort and I still put a piece of wood. The same applies to the set screw / plate. Per screwdriver to move not at all, it finally went with a pipe wrench and enormous effort. One must both also ummontieren. The door is now well 6mm moved to the right, because the top plate sits inaccurate. Through the rubber seals is all still tight.
As you so often not an exchange performs, that is acceptable, but a bit more accurate production would be desirable. On delivery (clockwise) everything was fine.
