The surface is relatively scratch resistant and anti-reflective coating well. The punched holes for the front camera fits. Only the film is at least 1 mm too large in height and the radius at the corners is too small. The too small radius causes the film therefore goes beyond the edge of the display and also rests on the metal rim - hence it does not stick on the corners and stands out brightly. Just below where the film also leaves the display glass and lifted by the metal rim - it dissolves about 5mm from the bottom (light like a bubble) from. That does not look nice. (I do not understand why you do not do the film 1-2mm smaller, on the edge of the area but it does not matter.) Sorry, no recommendation, but I do not know any good alternative.