Processing:
beautiful stainless steel, brushed. Makes a high impression. Likewise, the gilded connector.
However, since no protective film on the sheet, you should take time before unpacking from the blister directly a look at any existing scratches. The no longer one gets away namely ....
The connectors are gold plated and are likely to provide space 4mm² cable. My 2,5er I was able to throw.
The screw is super. Because the connectors are secured with a nut, you can make the rear introduction variable.
From the front you can either use banana plugs, or also screw the cable.
Here is likely to go through a 4mm².
The screw connection in the can is however tükisch. The standard doses are in the plaster a little smaller than the hole size Tick. Therefore you have to fumble somewhat when screwing. If you have the hang of it but only once it goes quite well and the things sit Bombenfest.
Stupid thing is that you can not vary the position of the switch, because the UP cans yes possess only 2 screw holes.
So when plastering the cans eighth embarrassing that the two holes are sitting in the balance, otherwise the panel after hanging crooked.
That's the only thing I can complain about. Here I do not have the real claws system of normal outlets.
Especially when the cans were plastered by a predecessor and this was very creative ...... :-)
All in all I can only recommend the Dinger. They look classy and are well crafted.