PureLink Pure Install series PI5000-030 - certified DisplayPort cable (Displayport 20pin male to Displayport 20pin male) - 3.0m - black (Accessories) 5
My problem so far: in some games I had at the above configuration, a "flicker" (image dropouts who have shown every few seconds in short black images) are not reproducible, not by changing the CPU / GPU values to influence. I've Forums scours. On top of that I have long since made me professionally especially in GPU / SLI and (thought) through a lot of testing and read and apply Real Life, have gained experience. My mistake: So far I have worked exclusively with DVI-D. GSync but only uses DisplayPort. DP provides in its SPEC only HD. Only from DP 1.3 (there's only since Sept 2014 Spec and as available cables since Nov 2014) WQHD @ 144Hz is supported officially. So if you, as I said, that you with the purchase of a (then) 800, - satisfies monitor the supplied power cord the necessary Spec: NÄÄÄÄh. The Good News, this cable transmits. And it transmits fully (in the 3-meter version). For "rough" test, I have it stapled over a meter in parallel to a 220V power cable (to provoke interference effect) and capacity. No dropouts. Thus: For the combination SLI (dual) GPU @ Asus Rog Swift GSync and nonsync (tested in various engines up to 200 FPS SLI 780 ti / driver 350.12 Nonsync / GSync 120/144 fps / 144 FPS Vsync) clear recommendation!
