Schade unfortunately makes our fridge noise and plenty of it, our old AEG contrast was 16 years old still. Ok what do you reduce not all about electricity costs, so we can not accept this as just noise. Unfortunately a lot of the renovation of the door hinge, a defect of the guide sleeve on, this was just broken in two and was only held together by the hole in which it lies. Amazon offered us only the Ausstausch the device, a replacement part would be no reason to fear. We think that's not so good for a penny items to replace the whole cabinet again, especially since you have had to live a few days without a fridge anyway. Another flaw is now we noticed the upper butter compartment in the door does not stop in the designated holding noses, the tray simply clamped variable and depends always wrong. In our opinion, these tabs are here in the door is not properly marked, so the refrigerator must probably still be swapped. But we try to provide an answer on Siemens to find, perhaps, it is possible simply just to get the door again? Had to us the best solution, a buy recommendation but we can not give it quite a bit missing. Also we would not opt for this device, on the one hand the noise is nevertheless already relatively loud, and the processing can also be room for improvement. We only hope that Siemens can help us better if not go back the part and a Liebherr is moving in with us. PS: Made in Turkey ... also says some of the devices come quite around until they find their way into our German kitchens. Siemens also seems to be no longer what it once was!