In the present me guidance from Dectane spoken by M8 screws for mounting.
In fact, were at my model inside and outside M5 M6. The Dectane lights have M6.
It may need to be kept ready with washers 4x M6 nuts!
The replacement of the tail lights se was not a problem, however, still needs a cable
be drawn from the respective inner rear light to the outer.
And here began with me the problems of ...
... Because first the complete interior trim of the tailgate has to be removed.
That's as far as okay. Here with me are due to the equipment of the vehicle
relatively large number of cables in the cable gland. To me it was impossible, the cable included with rubber
to draw jacketed plug through the implementation (on both sides). I was left nothing else than
abzuknipsen the connector with a pair of pliers and to solder again following (each only 2 wires).
The cable I then glued to a large cable tie and pulled through the implementation. That worked then.
Then pulled out behind the fairing, soldered connector, connected runs.
For someone with technical skills of remodeling but it should be to create in 2-4 hours.
Summary:
Built so great, but if you're not ready first, you will be rewarded by the appearance! Pictures I've attached. About the quality of the lights I will report in 3-6 months.