!!! Attention in the following installation is mandatory caution !!! Here, current flows !!! 220 Volt !!!
>>> In working with current workspace in the fuse box Normally / current free make visually looked like this: on a copper wire coil were 5 held shouldered with screws electrical connections. Links 2 times 220 volts then a small plastic partition and right 3 times 12 volts.
If necessary, before check voltage and connect the 2 cables of bell delivered to die12 Volt connections of doorbell.
Switch fuse and at the front door ringing (press). If there are 2 right 12 volt cable, then the gong must trigger. (With a minimum time delay ~ second.
Have moved through the slots of the doorbell cover the 2 x 12 volt cable. The bell from Gong still gets a double-sided adhesive and is glued to the cover.
The release from the Gong is now connected with the ring at the front door.
Voila, Finito ... am very satisfied.
Time: less than 60 minutes from ... and you can hear throughout the house who is coming