i-tec USB 3.0 Internal 4 Port Hub Front Panel

Had until now a front panel with USB 2.o with Temp.Anzeige and fan control in the 5.25 "variant
However, a motherboard with USB 2.o
Of course on the new motherboard also usb 3.o exists because I wanted to keep the "Old Front Panel"
had a new forth and best equal to a 3.5 "I can do without AudioAnschlüße quite,
my 5.25 "bays are full, the clutter is becoming more, rather than less.
This front panel met my expectations, but unfortunately not all.
My computer is with all the ingredients in red / black, built himself together,
since a blue cord does not as well.
In the manual is a FAQ in it:
Quote:
This port is mainly used for the charge of the brand "Apple" products determine which need the supply 2.1V.
Unquote.
Seems so to be so, the connected devices, some about not charging properly
or it takes forever until the full charge to notice.
I have the upcoming / outgoing voltage is not to be measured and also not further tested.
Since I have built only yesterday the front panel a.
Shall therefore be likely to use for charging devices my "old front panel" on.
Addendum:
Even barely literate times. In the manual is 2.1V, in the product description on Amazon 2.1A
I guess that's a "small" difference, otherwise I would have missed the profession
Printing or typographical errors? So then perhaps times measure the voltage and current.

The installation itself turned out to be something very delicate.
I as a craftsman and worked in the electrical / electronics industry knows what I write
The screws supplied are useless because the screw heads are very small
and for slightly wider gaps in my case are therefore unsuitable.
I for over 25 years my PC's retrofits and screw itself together I have enough spare material.

Conclusion:
The part does what is,
worked right away,
was recognized by the system Win7prof immediately,
there was no need for additional software.

Can I good conscience confidently
Because of the small flaws, and the charge port with 2.1V
but a star deduction.