Now for the preparations: The two-piece programmer, the CI + module and a Y-USB cable came with no explanation in a box.
First you have to three things of [...] Download (to see [...] is a link in the comment 1 (see below)):
1. [...] -> "Tools and How To" -> "New Unicam Programmer" PDF Manual (unicam_programmer_2 (en) .zip).
2. [...] -> "Tools and How To" -> "Download Unicam Loader v2.0" the Loader (UniCamLoader2.0.zip).
3. [...] -> "Download for UNICAM / UNICAM2" -> "Sparta 5:40 (10/12/2012)" the firmware (sparta_v5.40.zip).
I have then "own documents" folder "Unicam" made clean copies all three files there and unzipped it.
Then proceed just after the pdf manual. It is very easy and takes about 5 min.
Here are a few hints:
The drivers have been properly installed automatically with me (Windows7, 64bit) after I had joined the Programmer (3 min).
Under 4 must turn on the switch on the still plugged smaller part of the programmer after which the predicted lighting
the red LED only with about 10 seconds delay occurs (I thought that the thing was broken).
Under 5th starting the loader "UniCam Loader 2.0.exe" This left me with COM8 selected. Everything was OK automatically.
Under 10 you should under Start -> Enter run "devmgmt.msc".
Here you get some may stumble, if you start anywhere under "Run" takes place (Windows7).
This menu item in the Start menu so you can possibly bring to the fore:
> Activate option "" Run "command," Apply, OK - Right click on the taskbar -> Properties -> Start Menu tab -> Customize ....
After "Run from the Start menu in the lower right.