In many ways a throwback

Previously, we had a Pixma MG5250. The printer was very quiet, had a very good print quality was wonderful and closed in the off state, especially against dust. The normal paper tray was housed under the casing. For photo paper, there was on the back of a zuklappbaren catchment, so this paper, which is a bit stubborn usually as plain paper, without being bent by 180 degrees, could run through the printer. Both allocations could be used alternately, had to be removed or replaced without the paper. Because this printer abruptly gave up the ghost, the MG5650 was procured as a substitute. This 'newer and more modern' is in my opinion a step backwards in terms of material quality, service and volume. If you do not want it used for a long time, you have to remove the paper, so you can close all openings. If you give it back inside, must be 'confirmed' it. In addition, there is only one reservoir for all paper grades, ie. change if necessary and confirm again. Additional property A4 paper forward out of the printer and the drip tray for printouts is get very small. That's why the new device has been returned. If you all had previously can see, there would not have been ordered.