This module I installed under re-use of old lamps. If you have the Plus found by the passing beam is easy to install.
The cables are combined with Isoschlauch and poured module in DRL (here should be no moisture penetration) and of sufficient length. Confusion actually impossible. The cables are all prefabricated with Japan plugs or terminals. But I have crimped new plug, as I did not need the cable in length.
Installation time about 20 minutes. Tip: a few cable ties to clean embarrassed with schedule. I also have the plug contacts additionally provided with heat shrink tubing.
Conclusion:
Grown and works to R87.
- Start the engine, light bulbs
- Switch on the light, TFL expires
The TÜV has waved through it so.
For me to continue to use the simplest solution my old TFL again.
One more thing about bulbs:
I have seen here on Amazon and such inexpensive TFL`s with bulbs.
I deliberately used the old lamps that are a few years off, have survived all the washes and especially the necessary stamp in glass. The TÜV is looking for something.
The "cheap gizmos" there is no information, so pig in a poke.
Was this helpful? Then please click: o) Thank you!