Interested robust clamping table

I have two of these tables and use them frequently. Eg. for milling grooves in boards of 36 mm thickness and up to 4.50 meters in length (30-50 cm depth), the floorboards then weigh before a hundredweight or more. But let handle themselves just fine with two such tables, board is put to the side and clamped edgewise.

The building needs some time, so a table has oodles screws, but is then very stable (surface should be halfway up), once I had been almost tighten all the screws, because the tables were a little shaky. Folding is also good, I'm doing but rarely. Especially easy the tables are not just for transportation, but quite robust.

The four supplied plastic pieces often have a simple set of smaller workpieces (wood), very convenient if you get used to it. Overall, a recommendation for work with very long workpieces, if you have 2 of the tables!

If the tables at any time buy back, the better models that can be used as a machine table, I think is not so successful.