Who is a highly polished, perfectly executed high-end device expects at the juicer, is certainly wrong of place. Nostalgic boorish Ostprodukte and notorious tinkerer come against their money. The casting seems to be cast with molds from the early 70s, interest in what country? The attachment to the table is not because of abraded metal edge not really grip and can also lead to the supplied plastic inserts in damage to the table. I'll regrinding this edge with a flex in my Bastelkeller. The fact that ordinary kitchen plates are approximately 4 cm thick must be pitched at producer recently. The press can be just as secure on a popular countertop. The seal between the crank and auger has definitely symbolic, but is not necessary because the internal conical shape prevents leakage of freshly squeezed juice and healthy. Who his fingers something worth that prefer the screen to clean rather with a pair of pliers. The same applies to the insertion of the wire. And here's the amazing thing: The juice yield is surprisingly high, even in otherwise difficult to be pressed berries! Ergo, I have seen the product grew on after the first test and granted him a permanent place in the kitchen. This juicer I keep! Meanwhile, I have sanded the metal edge and the press can be pretty good fix on a kitchen plate. I'll have to deal with electroplating, because the now level surface is like rust expected set. The support disc on the clamping screw has fallen during unscrewing. But this can be repaired easily by tapping the wide end of the threaded pin and previously naturally draufsetzt the support disk.