This product will light a first, a red sticker "This unit is intended for wall mounting" counter. Why this is so, I can not quite understand, after all, the device also has nice rubber feet and is quite stable on the floor or wherever. It should probably be avoided in that it is somewhere where it gets too wet and therefore a hazard. But there should be against the wall anyway, that was no problem. When you turn on immediately the pleasantly quiet operating noise drops to (70dB (A) according to the instructions). However, the pressure and the pulse rate is a little low and not very convincing. Therefore, a star deduction. Energy technically minded is informed that the power switch does not make any real network separation, but the unit also consumes approximately 2.5W in off mode, the so-called stand-by consumption. Probably the engine runs with low voltage and the upstream transformer is connected on the secondary side. Pull the plug here worth so because that adds up to just 22kWh per year. Another minor drawback is the rather "fiddly" accommodating the nozzle and the hose, the happy times next slide and then hangs in the way. In addition, the nozzle holder is closed down, that water droplets do not expire and dry too bad, but will ensure the passage of time for an accumulation of dirt that you probably use a cotton swab must remove. Therefore together yet a star deduction. To conclude, that although AEG brand name on the outside, but as a producer or importer in the manual, the "ETV - Electrical Distributor" in Kempen occurs.