No Evil Eye - accurate and very cheap

The panels are (unpainted =) from black ABS plastic.
With me rubber strips were on the back of it. These strips not held, which is why I have moose per P1 1K PU adhesive ZB079 () used for sticking.
Advantage of the adhesive: It takes a long time until the glue hardens. Therefore, you have enough time to align the apertures at the desired location and secured with adhesive tape until the glue is dry (approximately 24 hours should be enough).

Before painting, you should check whether you have to edit the aperture with a hair dryer. In my case, the diaphragms were perfect, so I could give the unchanged painter (painting costs about 50 euros).
If someone wants to paint himself: To paint plastic, one needs Primer (= primer for plastic), otherwise the paint stops just a short time. Only then can you apply the color, and then go over it with clear lacquer.

Scope of supply:
- 1 set of front plate with double-sided tape on the back
- Expertise with silver lining, which is to confirm the authenticity of the certificate

Tip: rubber on the headlamps grease, so that the aperture slip easily Unters rubber with soap (eg Pril). Here, be careful that you do not purely pushes the rubber in the fender. I have also ever solved the upper two screws spotlight, so I had a little more space.
Note: After assembly should be allowed to perform a light test.

Note: According to the manual it might be necessary that you have to cut off the headlights rubber. This tip I would not follow, otherwise the fender is not waterproof!

I made a few pictures. See product photos.