Another point of criticism is the design of the machine and its components for me. The cone of the press is a little too flat and could have something sharper edges for reaming of fruits. The metal container captures the grated flesh on what remains lie in. After pressing you can then paint with a spoon again on the collected pulp to push remaining juice in the juice container. Here, however, bother me the wide slots through which the juice runs. They are so wide that lands me too much of the pulp in the juice. So far I have squeezed out with a Bosch ProfiMixx44 the juice. The machine with accessories had the same price as this AT312 alone. When the Bosch press cone was associated with the collection basket for the pulp. So the pot was rotated at the cone and looked like a centrifuge. The remaining in the detached pulp juice was centrifuged gently this way and did not remain in the basket. But also had a disadvantage, if you wanted to squeeze a little more juice. Then the juice began to rotate. So "nobody is perfect".
The material of the juicer makes a very good impression. They all very "valent" from. Bin To really evaluate any material expert. The machine does not like it so much, as I had hoped. Clear point deduction's because of the volume that could be significantly reduced through a more fitting gear. Nevertheless, the device works quite well and remain here, if only because I do not want to put other devices on the countertop me.
