Despite many negative reviews (often in terms of the editor), I decided to purchase and have not looked back. The guide (leaflet) is indeed poor, but to take enough to turn the unit into operation. The supplied label roll (62mm endless and though 29x90 mm are barely filled sample roles, so that a full roll of also ordering makes sense. After connection (network and USB), a drive to be recognized due to the built-in software. There, the boot file to run, and you will see a simple editor. The inserted part is automatically detected and you can print the first simple labels. If you want more, installed from the supplied CD to Editor 5.0. This can then also be more complex print labels, such as photos embed -Of course only in grayscale. The conversion from color to grayscale may be made in the editor, as well as the intensity of the grayscale. A lot herein described problem that the software does not recognize the printer is likely to the "faulty operation" of the printer. If one is going exactly according to the on-screen instructions when installing the editor (when is turn on and connect what) the software is properly installed. Now, note the following. If you want to work with the built-in software, so this must be enabled on the printer. These Holding the button next to the power button for 1-2 sec. Until the green light. Now you can work only with the built-in software, but not to the Editor 5.0. If the software you turn off again (push button until the green light is off), you can only work with the Editor 5.0, but not with the built-in software. By observing these points you will be with the printer have a lot of fun. I hope this review was helpful to you and has been able to clean up some negative judgments.