I ordered both these Holzinger Werkstattwagen HWW2009 and 2 Holzinger Werkstattwagen HWW1005KG. The latter perform considerably better. But here the HWW2009.
The packaging was mE sufficient. But after unpacking I stood in front of a small riddle: How do I get the little box from the great out - it is slightly wider than the front opening? But soon I found a screw-on cover left in a big machine. After its unscrewing the little box was still not come out of the great - until I found the locking screws on the underside of the car. Now kan the small box andlich from the big out.
The assembly was so simple that my dog it almost can make: The two handles on the little box screw and then insert the four wheels in a big machine. But here comes mE already the largest deficit on the carriage. Two of castors wolten only with great effort in the opening provided, two fell in quasi Freine case therein. But thus the last two fall immediately back out of the holder when the car is raised what is necessary for example, you want to raise him Üner a threshold. Goofy, because then you have to use them beyond the threshold again, because they are then on the floor. I then clamping rings bent to the wheels at least not fall out immediately. But, the castors can not steer. If a castor wheel is not already there in the direction of travel, it will remain in its wrong position and is ground on the ground. Not so good for parquet or laminate. This applies to all four wheels.
The drawers are mE okay - it is quite easy opening and closing. The lid of the small box is a little stiff, but otherwise okay. What I did not know is that you have the small box just above the side opening (the arrival and must be unscrewed) in the big box into it and gets out - I thought that goes over the front flap. Since I did not want to do anyway, I do not care. But I assume that the manufacturer has not provided that regularly packs and heirzu each side opening on and unscrewing the little box in the large. In addition, the insufficient völlg castors that do not draw leave, anyway no longer pushing or pulling means. Under these circumstances, I wish so but an intermediate liner on the lower part of the car. So I köönte there on two levels larger tools - such as drills, electric screwdriver, e-jigsaw, etc. - put. So I only have the ground and upwards much unused space.
For approximately EUR 100 but I did get what I ordered. That the castors can not be "hit" at this price was already clear to me, however, that they are not completely useless. The castors I will probably have to change and how I've seen so far is already significantly above EUR 30 cost. That there is another better, to show the roles of HWW1005KG.